YURSIN New 3000W 110V Electric Water Heater Indoor Use Stainless Tankless Water Heater with LED Display Adjustable Temperature for Hand Washing Compact Design Home Bathroom Kitchen

2024 Update New Mini Instant Kitchen Hot Water Heater with LED Display Adjustable Temperature For Hand Washing, Compact Design Home Bathroom Kitchen Use Specifications Color: /White/Black Material: Stainless Steel, ABS, Brass Process: ABS Particle Injection Molding Shape: Rectangular Style: Mini, Instant Mounting Type: ‎Wall-mounted, Vertical Usage: Indoor Use Features: With Leakage Protection Water Inlet Mode: Lower Water Inlet Heating Method: Instant, Stainless Steel Heating Core Power Source: Corded Electric Plug: US Standard PLUG Voltage:110V Frequency: 50-60Hz Power: 3000W Water Pressure: 0.04-1.2MPa Anti-Electric Shock Type: I Waterproof Grade: IPX4 Wire Requirements: ＞2.5m² Circuit Breaker Switch: ＞32A Heating Time: About 5s Interface: 1/2″NPT Interface Outer Diameter: 20mm/0.78inch Heating Temperature: 20-50℃/68-122℉ Power Cord Length: 1m/3.28ft Total Height(Interfaces Included): 19.5cm/7.7inch Water Heater Size: 11.6*7*19.8cm/4.57*2.8*7.7in Package Size: 23.5*19*10cm/9.25*7.48*3.9inch Net Weight: 1kg/2.2lbs Gross Weight: 1.18kg/2.4lbs Package Included 1* Instant Water Heater 1* English Manual Notes The unit is mainly for sinks, not for shower purposes. Please verify this unit is the right size for you before buying. The wire is required to be more than 2.5m² and the circuit breaker switch is greater than 32 A. You need to prepare a water pipe, valve, and other excluded accessories yourself. It must be installed vertically upward instead of horizontally, sideways, or flatly. Please properly ground the ground wire during installation, and it is forbidden to use a mobile socket. Beware of potential safety hazards in electricity use. Improper installation may lead to major safety hazards. It is recommended to install by professionals instead of yourself. Please make sure the water heater is mounted firmly to bear the weight of the water heater after it is filled with sufficient water. The electric water heater should be installed indoors, where the ambient temperature is above 0°C. The pipeline should be centrally arranged and the hot water outlet should not be too far from the hot water use point. The power switch should be installed on the cabinet and should not be touched by water. During installation, pay attention to the safe distance between the water heater and the gas pipeline, and keep the water heater at least half a meter away from the gas appliances, gas pipelines, gas meters, and other sources. The length of the water outlet pipe of the water heater is recommended not to exceed 3m. Otherwise, the water pressure may not be enough to start the machine because the water pipe is too long. (If the water tower is used in rural areas, the height of the water tower is required to be higher than 10m to make the water pressure reach the starting value). If the display screen shows E1(overtemperature), E3/E4, or temperature sensor failure, first cut off the power, use cold water to pass through the machine once, and then use it when powered on. Note that the water flow should not be too small at ordinary times. Please make sure cold water flows through this water heater before your first time use. Please check whether the power supply is normally powered on. The indicator light on the power-on display will show the temperature, but it will not light up if it is not powered on. If the temperature does not rise, you can press the temperature control switch or replace the heating pipe.